Snow Performance Gas Stage I The New Boost Cooler Forced Induction Water Injection Kit
The Snow Performance Stage 1 Boost Cooler® water-methanol injection kit is available for all forced induction applications (supercharged/turbocharged). Operation is simple and reliable: the system starts injecting when the boost switch reaches the user-adjustable point and injects a fixed amount of fluid through the nozzle until boost goes below the set switch point. Proven to deliver 30-70 HP increases to all forced induction applications!
This makes it a good choice for low to medium boost setups (1-15 PSI) looking for an octane enhancement and cooler intake charge. Activation can also be set up through any other user-chosen switch, such as a full throttle switch, nitrous switch, etc.
*Kit Includes:*
* 300 PSI UHO (Ultra High Output) Pump
* 3 Quart Reservoir
* All Tubing Necessary for Installation
10' ¼ Inch High Temp Nylon Tubing
18" High pressure Boost Line
3' (Black) Wire Loom
* Boost Switch (1-15 PSI)
* Pig Tail Harness
* Level Switch Upgrade
* 1 Nozzle Holder/Check Valve Combo
* 3 Hyper-Sonic™ Nozzles (175, 375, 625 ml/min) For Applications up to 1,000 HP (for custom nozzle selection give us a call at 719-633-3811)
* Required Hardware Needed For Installation
* Snow Performance Running S Decal
* Comprehensive Instructions to Install on Any Forced Induction Vehicle
* Snow Performance 1-Year Warranty